Lens Installation

Replace Full-Frame Sunglass Lenses

Remove: Hold the frame firmly, pull the top outward, and push the old lens out from behind.

Insert: Position the top of the new lens into the nose bridge groove first.

Secure: Press evenly around the edges until the lens clicks securely into position.

Tip: Use warm water to gently heat and soften the frame.

Replace Half-Frame Sunglass Lenses

Grip: Hold the frame firmly at the nose bridge with one hand and the lens with the other.

Remove: Gently pull the lens until its inner tab releases from the nose socket.

Insert: Position the new lens by hooking its outer tab into the temple socket.

Secure: Press the lens inward until its inner tab clicks into the nose socket.

Replace Wire-Frame Sunglass Lenses

Loosen: Use the provided screwdriver to loosen (but not remove) the small screw at the temple edge of the lens.

Remove: Gently release the lens from the metal frame.

Insert: Carefully position the new lens, ensuring its edges sit securely in the frame's grooves.

Tighten: Firmly but carefully tighten the screw to lock the lens in place.

Replace Shield-Frame Sunglass Lenses

Remove: Gently lift the top edge of the frame upward and push the lens out from the front. Repeat on the other side.

Release: Slide your thumb between the lens and the frame near the nose bridge to pop the lens out completely.

Insert: First, align and snap the top edge of the lens into the frame groove. Then, use both thumbs to press evenly around the lens edges until it is fully seated in the groove.

Tip: You may use warm water to gently soften the frame edges for easier lens installation.